HALdrive N20 - 20 Bit NX-02 Analogue Converter

The HALdrive is an adapter module to operate analogue scanheads together with a NX-02 or NX-02-compatible scanner controller card. It is fully adjusted, ready to be used and needs to be electrically connected only for operation.
It provides the following features:

• 2D or 3D NX-02 input signal
• 2D SL2-100™ input signal
• ±5V..±10V analogue output with 20 bit resolution (specify your desired voltage range during ordering)
• wide range power supply: +-12V .. +-24 V
• simple 1:1 connection with NX-02 extension board of E1803D contoller card possible
• simple connection with any other NX-02 compatible device as only two signal wires are needed where even the polarity does not matter
• instant-on, no bootup time after power-up
• small size of 62x45 mm

So it can be used to connect a NX-02 digital controller board to an analogue scanhead and will guarantee a low-latency, fully synchronous operation.